DOHC Distributorless Ignition Kit

Complete mappable distributorless ignition kit for Fiat DOHC engines.

More details

Pack content

1 x Distributor Hole Plug

Plug to fill your distributor hole on DOHC engines.

1 x Crankshaft Sensor Mount

Crank sensor mount for aftermarket injection and ignition.

1 x 4 Cyl Coil Pack with Straight Plugs

Works with the ford EDIS4 and EDIS8 systems. This plug typically works better for retrofits because you do not have to change plug wires! Also has a flat bottom which is much easier to mount than the "clip-on" types of coils.

1 x EDIS Module

For use in distributorless ignition setups.

1 x Coil Pack Connector

We can supply for all Ford coil pack types, 4 or 6 cylinder.

1 x Megajolt Advance Controller

Fully programmable/mappable ignition controller. Can be setup for either MAP or TPS signal.

4 x NGK Performance Spark Plugs

Performance plugs to match your performance engine.

1 x VR Crankshaft Sensor with 8ft Shielded Cable

Universal VR crankshaft sensor.

1 x Crank Pulley with Trigger Wheel

Aluminum crank pulley with trigger wheel for DOHC engines.

1 x High Performance Plug Wires

8mm performance plug wires for use with our flat bottom coil packs.

More info

Everything you need to install a distributorless ignition on your Fiat DOHC engine.

This price is for our most basic kit, optioned using MAP, a single groove crank pulley with trigger wheel and used (tested good) EDIS module. If you'd prefer more advanced options contact us!